How to install thermal conductive silica gel sheet

Installation of thermal conductivity materials is also a part of the work of many electronic equipment manufacturers, because thermal conductivity materials are an indispensable part of all kinds of electronic equipment. Only after the correct installation of thermal conductivity materials, can make the radiator play a greater role in heat dissipation, heat dissipation efficiency will be greatly improved. Next, we will talk about the installation methods and precautions of the thermal conductive silica gel sheet which are used more frequently in the heat dissipation materials, so as to facilitate you to have a more comprehensive understanding of the thermal conductive silica gel sheet and its installation mode.

1、Before Installation

When installing thermal conductive silica gel sheet, it is necessary to carry out a detailed inspection on the surface of the installed component. The main thing is to ensure that the surface is clean and dust-free. Only in this way can we ensure the best thermal conductivity. When taking the thermal conductive silica gel sheet, especially the large area of the thermal conductive silica gel sheet, we try to grab it from the middle part by hand, so that we can try to avoid material deformation due to uneven force around, so as to ensure the integrity of the thermal conductive silica gel sheet.

2、Installation in progress

When installing thermal conductive silica gel sheet, it is necessary to carry out a detailed inspection on the surface of the installed component. The main thing is to ensure that the surface is clean and dust-free. Only in this way can we ensure the best thermal conductivity. There is a protective film on both sides of the hot silicone sheet, so the protective film needs to be torn off manually during the installation process. What should be noted here is that we should try not to open the protective film on both sides at the same time, tear off one side and then gently put down the thermal conductive silica gel sheet. Pay attention to the generation of bubbles when putting, if bubbles are produced, it will affect the thermal conductivity effect. After determining the location and placing well, you can tear off the protective film on the other side, and then put the radiator on it. It should be noted that if there is a bubble in the process of installation, it can be slowly opened and then put back, but the process must be slow.

3、After installation

After the installation of the thermal conductive silica gel sheet, the radiator needs to be put on. After the radiator is placed, it is best to press the radiator hard for a while, so as to ensure that the surface of the thermal conductive silica gel sheet and the radiator are fully combined, and it also plays a fixed role. If conditions permit, the heat sink and thermal conductivity materials can be pressed and stored for a period of time, so as to ensure that the location of the two is fixed.

In fact, the process of installing thermal conductive silica gel sheet is very simple, mainly to test everyone in the installation process to be patient and careful. In this way, the sealing of thermal conductivity materials and radiators and electronic components can be ensured to be better, and the efficiency of thermal conductivity can be higher.